|
NT-6006, Dual Telephone Line Tester
Instructions:
IMPORTANT: Always test the phone line before connecting your computer modem.
Step 1. Test line 1 by setting the Line Switch to position "1". Position "1" on Line Switch tests the inside wire pair. Position "2" on Line Switch tests the outside wire pair.
Step 2. Connect the RJ11 plug at the LINE end of "Digital Phone Line Tester" to the RJ11 phone line jack you want to test.
NOTE: Outside North America you may need an international Telephone Outlet Adaptor to convert a foreign telephone jack to an RJ11 jack. See country list in Voltage Valet's Foreign Electricity Guide for proper adaptor.
Step 3. Press the "TEST" button.
‧ Red light indicates a digital line. DO NOT USE LINE.
‧ Green light indicates a safe analog line.
‧ Yellow light indicates a safe analog line with reversed polarity. Phone line is safe but
reversed polarity may slow data transmission rates.
‧ No light indicates no signal present on the phone line. Set line switch to position "2" and
repeat steps above.
Step 4. To use the surge suppression circuit, leave the "Digital Phone Line Tester" plugged into the phone line jack as described in Step 2 and connect the RJ11 plug from the computer modem to the RJ11 jack at the MODEM end of "Digital Phone Line Tester". |
